Uncut Guide to Fix Linksys RE6300 Extender Red Light Issue
Did you bring a Linksys RE6300 range extender into your home and tried to perform Linksys RE6300 setup but came across the red light issue? Well, that is troublesome. But, worry not. We can help you resolve it. Following the troubleshooting hacks given below will help you to fix the Linksys RE6300 red light issue in the blink of an eye.
Before getting started with Linksys extender troubleshooting, it is recommended that you try to restart your Linksys RE6300 device. Perhaps, this is the only thing that you need in order to resolve the Linksys RE6300 red light issue. In case, this does not help you out, then it is advised that you walk through the rest of the hacks.
[Fixed] Linksys RE6300 Extender Red Light Issue
Verify the Ethernet Connection
A weak Ethernet connection is the number one reason behind the Linksys RE6300 extender red light issue. Therefore, it is advised that you have a look at the Ethernet cable that is currently holding the networking devices in place right now.
Do you find that it is damaged from some point? If yes, then consider replacing the Ethernet cable with a new one. Once you bring the new cable home, connect the extender and router using it. Make sure that the connection is finger-tight.
Although this hack will help you to put an end to the Linksys RE6300 extender red light issue, in case, it does not; it is recommended that you take your attention to the following troubleshooting hacks. Maybe that might be of some help to you.
You can check: Netgear Nighthawk WiFi Router Setup: A Few Easy Steps
Bring the Networking Devices Closer
Too much distance between the Linksys RE6300 extender and the host router can also cause the LED on your device to blink red. This is because too much distance can stop the signals of your devices from getting emitted properly thereby causing issues.
Therefore, consider reducing the distance between them. Apart from this, make sure that they are not kept too close to each other. That can cause more problems for you in the future. Perhaps, even much bigger than the one you are facing right now.
Avoid WiFi Interference
Bluetooth speakers, mirrors, fish tanks, cordless phones, washing machines, baby monitors, microwave ovens, treadmills, televisions, refrigerators, etc are all examples of reflexive surfaces, metal objects, electronic devices, and transmitting appliances.
These things can interfere with the signals of your Linksys RE6300 wireless range extender thereby stopping it from performing well and causing plenty of technical issues, similar to the one that you are experiencing right now.
In order to take care of this thing, you need to change the location of your Linksys RE6300 range extender. And make sure that you are not keeping the extender anywhere near these things. Once done, try to access http://extender.linksys.com.
Did none of the aforementioned troubleshooting hacks worked for you? Well, in that case, you need to restore your Linksys RE6300 wireless range extender to its default factory mode right away. After that, set up your device from scratch.
The Conclusion
After following the troubleshooting hacks mentioned in this post, you will surely be able to troubleshoot the Linksys RE6300 extender red light issue.
If you ever plan to perform Linksys Velop setup using the Linksys Velop login credentials but are not able to because of the Linksys RE6300 red light issue, then you can take the help of the same troubleshooting hacks mentioned in this article.
What do you think of this post? Did you like reading it? If your answer is a yes, then share your feedback with your fellow readers via the comment section.
Also Check: How to Do Linksys WiFi Extender Login and Setup?